Filter
Top Products
Leak Sensor Installation
-41-
Connect the Leak Sensor and its Wire Harness
Step 3: Connect the Leak Sensor wire harness to the Leak Sensor (specifically the end with the plastic
connector), as shown in Figure 54.
Prepare the Accessory Module for the Leak Sensor
Step 4: Loosen the screw labeled “C1,” as shown in Figure 55. Ensure that the Transformer wire harness
wire going to this same location remains inserted under this screw.
Fi
g
ure 54
Leak Sensor
Leak Sensor
Wire Harness
Plastic
Connector
Transformer
Wire Harness
Accessory
Module
Leak Sensor
Resistor
Philips head
screwdriver
Figure 55