Filter
Top Products
Leak Sensor Installation
-43-
Assemble the Leak Sensor Wire Harness and the Accessory Module
Step 7: Insert the red wire, from the Leak Sensor wire harness, under the screw labeled “C1.” This is
shown in Figure 58. Ensure that the wire from the Transformer wire harness at this location is retained
under this screw.
Connect the Leak Sensor Wire Harness and Accessory Module
Step 8: Tighten the screw labeled “C1,” as shown in Figure 59.
Figure 59
Transformer
Wire Harness
Accessory
Module
Leak Sensor Wire
Harness Red Wire
Philips head
screwdriver
Figure 58
Transformer
Wire Harness
Accessory
Module
Leak Sensor Wire
Harness Red Wire