Filter
Top Products
Start-up Procedure
-67-
In the following section, the instructions detail the Start-up Procedure for the Accessory Module,
once any or all of its packages are completely installed.
Route the Wire Harnesses in the Accessory Module
Step 1: Route all of the wire harnesses out of the openings in the bottom and left side of the Accessory
Module. And, hold them in place. This is shown in Figure 102.
Re-install Accessory Module Cover
Step 2: With all wire harnesses properly routed, place the Accessory Module cover back onto the
Accessory Module base. This is shown in Figure 103.
Figure 103
Figure 102
Accessory
Module
Route the Wire
Harnesses
through These
Holes
Accessory Module
Cover