Filter
Top Products
Remote Mounting the Setback Control
-58-
Label the Wires for Remote Mounting
Step 5: Label the (3) cut wires (A), (B), and (C) respectively. Label both ends of the wires. This is shown
in Figure 86. Masking tape can be used to label the wires.
Prepare the Wires for Installation
Step 6: Strip approximately 1/4” of the wire’s insulation from each end of the three wires. This is shown in
Figure 87.
Figure 86
Figure 87
Label Each
Wire
Strip
Approximately 1/4”
from Each End of
All (3) Wires