Filter
Top Products
Setback Control Installation
-30-
Locate the Setback Control Junction Box Assembly
Step 7: Place the Setback Control Junction Box Assembly on top of the water heater. This assembly must
face the front of the water heater, and it must be located close to the centerline of the water heater. This is
shown in Figure 34. The Setback Control Junction Box Assembly must be located as far from the draft
hood as possible, if installed on an atmospheric water heater.
Mark the Location of the Setback Control Junction Box Assembly
Step 8: Using a marker, mark the location of both holes in the Setback Control Junction Box Assembly.
This is shown in Figure 35.
Fi
g
ure 34
Figure 35
Move the Setback Control
Junction Box Assembly as
far from the draft hood (or
blower) as possible
Water Heater
Centerline
Marker
Top of Water
Heater
Setback Control
Junction Box Assembly
WARNING
Do not mount the Setback Control Junction Box Assembly close to the draft hood.