Filter
Top Products
Remote Mounting the Setback Control
-60-
Install Wire (B) – Backplate
Step 9: Using wire (B), insert one end into the middle terminal location on the backplate (located on the
Setback Control Junction Box Assembly). This is shown in Figure 90. Be sure that the wire already
located in this location is not dislodged.
Fasten Wire (B) into its Designated Location – Backplate
Step 10: Tighten the slotted screw in the middle terminal location on the backplate (located on the
Setback Control Junction Box Assembly). This is shown in Figure 91.
Figure 91
Figure 90
Wires Already
Installed
Wire (A) Wire (B)
Backplate
Wire (A)
Slotted head
screwdriver
Backplate
Setback Control
Junction Box Assembly
Wire (B)