Filter
Top Products
Setback Control Installation
-31-
Remove the Setback Control Junction Box Assembly
Step 9: Remove the Setback Control Junction Box Assembly from the top of the water heater, as shown in
Figure 36.
Drill the Setback Control Junction Box Assembly Mounting Holes
Step 10: Using a 1/8” drill bit and drill, drill the (2) screw holes that were marked in Step 8. This is shown
in Figure 37.
Figure 36
Fi
g
ure 37
Setback Control
Junction Box Assembly
Top of Water
Heater
Top of Water
Heater
Drill
Marked Drill
Locations