Filter
Top Products
Part number 550-141-850/069944
GOLD GV Water boiler series 3 — manualGOLD GV Water boiler series 3 — manual
GOLD GV Water boiler series 3 — manualGOLD GV Water boiler series 3 — manual
GOLD GV Water boiler series 3 — manual
Start-up — read Section IXVIIc
Boiler sequence of operation
Manual Section IX contains information about the
operation of the boiler and controls. Read this
information, including the Sequence of operation
diagram, to familiarize yourself with the normal operation
of the control system. Note also the lockout conditions
of the boiler control module, found on the control cover
label.
Start-up — to operate boilerVIId
Perform final checks before
starting boiler
Read manual Section IX. Select the correct Lighting
instruction
procedure (Figure 25 or 26) based on the
gas valve installed in the boiler.
Verify the boiler and system are full of water.
Verify the start-up preparation procedures of Section
VIIb have been completed.
Do not use petroleum-based
cleaning or sealing compounds
in boiler system. Severe damage to
boiler will occur, resulting in
substantial property damage.
Verify that the gas/air orifice
plate has been checked (and
replaced if necessary) per manual
Section IIc. Complete this procedure
before starting boiler. Using an
incorrect gas/air orifice plate will
result in severe personal injury, death
or substantial property damage.
Start the boiler
Follow the correct Lighting instruction from Section
IX to start the boiler.
See Section VIIe if boiler fails to start.
Check system and boiler
Eliminate all system leaks.
Continual fresh makeup water will
reduce boiler life. Minerals can build
up in sections, reducing heat transfer,
overheating cast iron, and causing
section failure.
Venting system must be sealed
gas-tight to prevent flue gas spillage
and carbon monoxide emissions
which could result in severe personal
injury or death. Inspect vent system
per following.
1. Check system piping for leaks. If found, shut
down boiler and repair immediately.
Lighting instructions
Section IX also includes a Lighting instruction
procedure for each gas valve used on the GV boiler
(Figure 25 or 26).
Select the correct lighting instruction by reading the model
number on the gas valve (can be viewed with the boiler
front jacket panel removed). Use only the Lighting
instruction
procedure for this model gas valve.
Component operating information
Manual Section XI, Troubleshooting includes
additional information about the operation of specific
boiler components.