Filter
Top Products
II
19
4-4. Function controller
(1) Accessories
(2) Installation
1) Disassemble the function controller by using a groove on its
top.
2) Secure the rear cover of the function controller on the wall
with two screws.
3) Connect the C1 and C2 terminals in the function controller to
the same terminals in the centralized controller.
4) Reassemble the function controller.
Function
controller (1)
Cable-tie(2) Cable clamp
(6)
M4x16
Tapped screw
(7)
Owner’s
instructions(1)
Installation
manual (1)
◆ You must align the same terminal when connecting cables. If the cables are connected improperly,
the function controller will not work.
◆ The adaptor is not supplied with the function controller.
Keep the polarity below when connecting the adaptor.
- V1 : DC +12V, V2 : DC Ground
Centralized
controller
Adaptor
Function
controller
Function controller PCB
Rated input
Rated output
220V-240V/50~60Hz
DC8.5V 100mA
DVM E-D/B(chapter2)-E<03759 3/21/02 7:33 PM Page 19