Filter
Top Products
II
11
4-2. Wired remote controller
(1) Accessories
(2) Installation
1) Open the wired remote controller by using two grooves on
its top.
2) Secure the rear cover of the wired remote controller on the
wall with 2 screws.
3) Connect each F1, F2, V1, and V2 terminal on the wired
remote controller PCB to the indoor unit.
4) Reassemble the wired remote controller.
5) In case of 1-way Cassette type, connect terminals with the
main PCB of indoor unit as shown at the figure.
Wired Remote
Controller (1)
Cable-Tie(2) Cable Clamp
(5)
M4x16
Tapped Screw
(7)
Indoor Unit
Power Drawing
Cable (1)
Owner’s
instructions(1)
Installation
manual (1)
AC Power
supply
White
Black
CN43(White)
Main PCB of indoor unit
Wired remote
controller PCB
◆
Be careful about the cables so that they will not be mixed up.
NN
NN
oo
oo
tt
tt
ee
ee
◆
The wired remote controller must be installed by an installation specialist.
◆
Before installing the wired remote controller, ensure that you have turned off
the main power.
◆
All wired remote controller cables should be installed according to the
national wiring rules and you must install it in the wall not to be touched by
users.
DVM E-D/B(chapter2)-E<03759 3/21/02 7:33 PM Page 11