Filter
Top Products
V. Installation
2. Panel
V
16
Tapped screw
(6)
Fixing bracket
(1 or 2)
1) Separate the front grille from the panel.
1-1 Push the lever of front grille right and left to lift it up and
then open it.
1-2 Take out the safety clip at the both sides of front grille and
separate the front grille.
2) Insert panel fixing screws(4EA or 5EA) and tighten them
temporarily. Leave space of approx. 7~8mm between the
screw and the indoor unit to insert the panel. Do not insert the
screw into the rest of one or two hole(s) yet.
✻✻
020/026/035
✻✻
◆ Tighten 5 screws except one hole for fixing a bracket.
✻✻
052/070
✻✻
◆ Tighten 4 screws except two holes on right and left.
2-3. Duct type (Built-in)
(1) Accessories
(2) Installation
DVM E-D/B(chapter5)-E<03759 3/21/02 7:40 PM Page 16