Filter
Top Products
II
15
(4) Assigning address
Turn the arrow of rotary switch on the transmitter to appropriate
position. Transmitters controlled with the same centralized
controller must have different addresses.
Transmitter rotary switch
(5) Setting up option switches
In case of installing centralized controller only
Adjust K2 DIP switch(SW03) on the indoor unit PCB to the
“OFF” position. It means use of the centralized controller.
0
1
2
3
4
5
6
7
Button No.
0
1
2
3
4
5
6
7
RMC
Address
8
9
10
11
12
13
14
15
Button No.
8
9
A
B
C
D
E
F
RMC
Address
K1 K2 K3 K4
RMC SW01
SW03
◆
The number of button on the centralized controller is decided by
the RMC addresses of indoor units. Refer to the table below.
NN
NN
oo
oo
tt
tt
ee
ee
Individual control ;
◆ Means a centralized controller controls only 1 indoor unit. In this case, you should assign
the RMC address to the indoor unit.
Group control ;
◆ Means a centralized controller controls more than 2 indoor units. In this case, you should assign
the RMC address to each indoor unit to be controlled by the centralized controller and cannot use
a wireless remote controller.
NN
NN
oo
oo
tt
tt
ee
ee
DVM E-D/B(chapter2)-E<03759 3/21/02 7:33 PM Page 15