Filter
Top Products
44 C3662M (6/08)
USING INTEGRAL LICENSE KEY UTILITY
Integral License Key Utility allows you to enter a license key to enable various features in the Digital Sentry software. You can run the utility from
the Start menu under Programs and Integral.
The utility lists the product type and Product ID (for most systems, the Product ID is already entered). In the License box, type a valid license key
created for the Product ID. To create a trial license or to view the features enabled by an entered license key, click the plus sign (+) next to the
product type. This also allows you to create a trial (temporary) license.
After you have entered a valid license key, stop and restart the Digital Sentry VideoServer service.
USING REALVUE DIAGNOSTIC TOOL
RealVue Diagnostic Tool allows you to test the video inputs and triggers on a DS RealVue system. You can run the utility from the Start menu
under Programs and Integral.
The RealVue Diagnostic window displays the inputs from up to four video capture boards. Each of the eight inputs on each board displays video if
a camera is properly connected to the input. You can click an input’s small video window to view its video in the larger window.
To change the video standard, click NTSC or PAL. Alternatively, you can right-click anywhere in the RealVue Diagnostic window, select Video
Standard from the pop-up menu, and then select the standard.
To view a camera in black and white, right-click anywhere in the RealVue Diagnostic window, select Display Options from the pop-up menu, and
then select “Black and White.”
To view the status of the trigger inputs and outputs, right-click anywhere in the RealVue Diagnostic window, select Display Options from the
pop-up menu, and then select Show Triggers. This displays a number for each of the inputs and outputs. For inputs, 0 (zero) indicates that the
trigger is closed (connected to ground), and 1 indicates that the trigger is open (pulled or floating to high voltage). For outputs, 0 (zero) indicates
that the relay is open and 1 indicates that the relay is closed (only output 1 is currently available on DS RealVue systems).