Filter
Top Products
Parker Hannifin
176 Aries User Guide
Drive AC
Voltage
Motor Resistor
Rating
(Resistance
—Ohms)
Resistor
rating
(Continuous
Power—
Watts)
Isotek Part Number
120 SM162Z 100 100 BRK-100R-10-L2, 4
AR-01xx
240 BE164B See note1
SM162Z See note1
SM161A See note1
SM162A See note1
SM230A See note1
SM231A 47 200 BRM-47R0-10-L2, 4
120
SM232A 47 200 BRM-47R0-10-L2, 4
BE230D See note1
AR-02xx
240
BE231D See note1
SM233A 47 200 BRM-47R0-10-L2, 4
BE232D See note1
BE233D See note1
AR-04xx 240
BE233F See note1
BE230F See note1
BE231F See note1
120
BE232F See note1
BE341F See note1
BE342H See note1
NO702F 22 300 BRQ-22R0-10-L2, 4
NO703F 22 300 BRQ-22R0-10-L2, 4
AR-08xx
240
NO704F 22 300 BRQ-22R0-10-L2, 4
BE344L 22 300 BRQ-22R0-10-L2,3,4
MPM1141ASG 22 300 BRQ-22R0-10-L2,3,4
AR-13xx 240
SMN1002S2F-KPN 22 300 BRQ-22R0-10-L2,3,4
1141BSG 8 800 IRP20008R0J2, 4
1142BSG 8 1100 IRP30008R0J2, 4
AR-20xE 240
1421BSG 8 1100 IRP30008R0J2, 4
1142ASG 8 1800 IRP60008R0J2, 4
1143ASG 8 1800 IRP60008R0J2, 4
AR-30xE 240
1901BSG 8 1800 IRP60008R0J2, 4
1. External power dump resistor not needed. However, higher operating voltage, higher load to rotor inertia
ratio, and higher duty cycles can increase the need.
2. Higher friction loads, lower speeds, lower deceleration rates, lower load to rotor inertia ratio, and lower duty
cycles can decrease the need for this resistor.
3. Minimum resistance allowed for AR-13 is 22 Ohms, therefore the maximum deceleration rate and/or duty
cycle may need to be reduced.
4. Isotek resistor or equivalent
Table 57 Simplified Selection of External Power-Dump Resistor