Filter
Top Products
37
T
ROUBLESHOOTING
Erratic Sensor Alarm Indication (Red A IN LED blinks):
1. Check the positioning of the sensor to make sure it is oriented correctly.
2. Check to see if the sensor is dirty and clean it if necessary.
3.
Check sensor gain/sensitivity adjustment for correctness. Most sensors
provide this adjustment to adapt to various sensing conditions. Review
the documentation that came with your sensor to learn how to make this
adjustment correctly. If this adjustment is made incorrectly, the sensor
may produce an erratic alarm output.
Scanner cannot be placed in program mode using HoloSet label:
1. Disconnect then reconnect power to the scanner. Enter scanner
program mode by choosing Enter Program Mode from the HoloSet
Main Menu.
2. If the scanner has been programmed for sensor support, the scanner
will not scan any label including the HoloSet label unless a sensor is
connected to the MX001 box and activated.
3. If the scanner has been programmed to support DTR, the scanner will
not scan any label including the HoloSet label unless the DTR input is
active.
Scanner cannot be placed in program mode using HoloSet menu:
1. Disconnect then reconnect power to the scanner. Retry entering
program mode by choosing Enter Program Mode from the HoloSet
Main Menu.
2. Check to see if the HoloSet communication cable is plugged into your
PC correctly.
3. Make sure the correct COM option (COM 1 or 2 as required) is being
used.