Filter
Top Products
14
S
ENSOR
S
UPPORT
Connecting the Sensor
Reference the documentation that came with your sensor to determine the
function of each sensor wire. Then, refer to one of the procedures on the
following pages that apply to your sensor for information on how to hook up the
appropriate wires and position the configuration jumper on the appropriate pins of
its header. If your sensor supports the alarm function, begin looking for the
procedure for your sensor on page 22.
Temporarily Disabling the Sensor and/or Sensor Alarm
If, during set up or maintenance, there is a need to disable the sensor and/or
sensor alarm inputs of the MX001, proceed as follows:
• To disable the sensor, position the J1 (S SET UP) jumper on
pins 2 and 3 of its header.
• To disable the sensor alarm, position the J2 (A SETUP) jumper on pins 2
and 3 of its header.
These procedures disconnect the sensor’s output signals from the MX001’s input
circuitry without physically disconnecting any sensor wiring.