Filter
Top Products
BES-962BC • BES-1262BC
59
Chapter 3 Embroidering Procedures
Checks the embroidering area.
Exits from embroidering mode. Press this switch while holding down
STOP
switch
simultaneously to stop embroidering.
Moves the hoop automatically when embroidering position is out of the embroidering area.
Sets the machine to the inching mode when this switch is pressed during suspension.
Moves the hoop to software-set position. When this switch is pressed again, the hoop
returns to the previous position.
Moves the needle bar. The needle moves by the diameter every time this switch is pressed.
Moves the hoop.
Step-back or forward is available during suspension, by one stitch every time the switch
is pressed (Use
switches only.)
Changes the speed range during embroidering (Use switches only).
Carries out inching of the hoop when the switch is pressed in the inching mode (
appears on the panel).
Canceling errors
When an error message appears, it is canceled by pressing
STOP
STOP
switch.
Pressing other switches can stop alarm sound.
When thread breakage or wiper out error has occurred, step-back or forward
switch can be used to cancel errors.