Filter
Top Products
Chapter 5 Editing Embroidery Data
BES-962BC • BES-1262BC
110
The number for repetition is 1 to 100 for both vertical (Row) and horizontal (Column)
directions.
The unit for repetition can be set in inches. To use the inch unit, set the length to
[inch] on the [Configuration] of Tool menu of the machine controller. (
page 148)
The pattern connection can be set in "Direction" as follows:
From top left,alternating directions From top left,left to right direction
From bottom left,alternating directions From bottom left,left to right direction
1. Select [Repeat] from Edit menu or click .
2. Specify the number, interval and direction of repetition.
3. Click [OK].
Repeat count in the
longitudinal direction
Repeat count in the
lateral direction
The value can be directly entered.
Click here to increase/decrease the value.
Select the reference position for
spacing.
Select the direction of repetition.
All patterns created in repetition are grouped as a single pattern.
Longitudinal distance (Unit: 0.1 mm or 0.01')
Lateral distance (Unit: 0.1 mm or 0.01')