Filter
Top Products
Chapter 10 Adjustment
BES-962BC • BES-1262BC
241
* Precautions for tightening the two bolts e:
• The thread trimmer connecting rod B w
has a backlash of about 0.1 ~ 0.2 mm back
and forth. Tighten the two bolts e while
pulling them forward by the backlash
amount.
• Tighten the two bolts e so that the thread
trimmer connecting rods B w and C q
are positioned in a straight line.
Mount head No. 3 so as to make thread
trimmer connecting rod D r parallel with
the side of the bed. (Check that no
interference will occur during feed in the
crosswise direction.)
5. After adjustment is finished, reset the stop
switch.
"STOP" stops blinking and disappears.
6. Turn the power switch off once, then on
again. Check that the clearance between
the movable knife r and the fixed knife t
is 1 mm.
7. When adjusting again, follow the step 2 and
after.
q
w
e
* Bad example
1mm
t
r
r
Bed