Filter
Top Products
Chapter 2 Preparation of Embroidery Machine
BES-962BC • BES-1262BC
46
0.5mm
w
q
e
3-2 Replacement of Bobbin
Note) Remove dust, lint and oil from the bobbin case before replacement.
Removing bobbin case
1. Open the rotary hook cover B q.
2. Hold the knob w and take out the bobbin
case.
3. Close the knob and take out the bobbin e.
Replacing bobbin
1. Put a new bobbin in the bobbin case.
Check the winding direction.
Check that the bobbin is pushed out of the bobbin case
by about 0.5 mm. If not, the slip prevention spring of the
bobbin case does not work. Adjust the height of the
spring or replace it with a new one.
2. Slide the thread under the tension spring
t through the notch r.
t
Pull out by about
50 mm
Bobbin
3. Pull out the thread from the hole of the
tension spring t.
4. Pull out the thread by about 50 mm.
r
t