Filter
Top Products
Chapter 2 Preparation of Embroidery Machine
BES-962BC • BES-1262BC
44
BES-1262BC
No.2,5,8,11
No.1,4,7,10
Needle Bar No.3,6,9,12
3. Pass the thread through the upper hole of the 2nd pretension. Push up the thread guide
tension disc with your finger, and pass it from the left to the lower hole. Wind the thread
clockwise twice around thread breakage pulley e.
4. Pass the thread through the hole of upper thread guide(upper) r. Wind the thread clockwise
once around the rotary tension disc and place it on the spring.
5. Pass the thread through each hole of upper thread guide(middle) t and thread guide y.
6. After passing the thread through the hole of thread guide y, insert the thread into the right
side of the inner thread guide and pass it through the hole of the thread take-up.
7. Bring the thread back to the inner thread guide. Insert the thread into the hole from the upper
section into thread guide A u.
8. Pass the thread through the hole of the needle bar thread guide o and pass it through the
needle eye. Do not pass it through the presser foot. Pass it to presser spring at the front of
lower thread guide i.
q
w
Thread guide
tension disc
e
Thread breakage pulley
r
Upper thread
guide (upper)
t
Upper thread
guide (middle)
y
Thread guide
u
Thread
guide A
i
Lower
thread
guide
Rotary
tension
disc
Spring
Inner thread
guide
u
Thread guide A
i
Lower thread
guide
o
Needle bar
thread guide