Filter
Top Products
EMBROIDERING TUTORIAL
—
——————————————————————————————————————————————————————————————
——
62
■ Moving the needle bar to be threaded to the
embroidering position
You can move the needle bar in the
embroidering screen.
1
Touch the key for the needle bar that you
wish to thread.
X The selected needle bar moves to the
embroidering position.
Note
● If the thread is not taut, it may come out of
the thread tension disc. After upper
threading is finished, check again to make
sure that the thread is correctly passed into
the thread tension disc. (Refer to step
5
on page 57.)
Memo
● When changing one of the upper thread
colors, it is easy to re-thread by cutting the
thread currently being used between the
spool and the thread guide above the
spool. Place the new spool on the spool
pin and tie the end of the new thread to
the end of the previous thread. Then pull
the thread through to the needle. (Refer to
page 104.)
■ Using the spool net
When using metallic thread or any other strong
thread, place the included spool net over the
spool before sewing.
If the spool net is too long, fold it once to match
the size of the spool before placing it over the
spool.
It may be necessary to adjust thread tension
when using the spool net.
1 Spool net
2 Thread