Brother 884-T05 Sewing Machine User Manual


 
Starting/Ending Position Settings 123
——
————————————————————————————————————————————————————————————
——————————————————————
4
Starting/Ending Position Settings
The machine can set the start point and the ending point separately from the 9 points of the pattern. Those
are upper-left corner, upper-center, upper-right corner, center-left, center-center, center-right, lower-left
corner, lower-center and lower-right corner.
These settings can be used to repeatedly sew a pattern along a diagonal.
The starting/ending position settings are specified
from the embroidering settings screen.
When the embroidery machine is purchased, both
the starting position and the ending positions are
set to the center of the pattern.
1
Touch .
X The starting/ending position settings
screen appears.
1 Specifies the starting position
2 Specifies the ending position
Touch a key to select the setting.
The highlighted key shows the currently
selected setting.
Example
3 Touch this key to close this screen.
Specifying the starting position
2
Touch the key for the desired starting
position setting.
X When a starting position is selected, the
ending position is automatically set to the
same position.
X The embroidery frame moves to the
starting position.
Specifying the ending position
3
Touch the key for the desired ending
position setting.
4
After selecting the desired settings, touch
.
X The embroidering settings screen appears
again.
Memo
The starting/ending position settings do
not change until the key for a new setting
is touched. The settings specified before
the machine is turned off remain selected
the next time that the machine is turned
on.
This key is selected.
1
2
3