Brother 884-T05 Sewing Machine User Manual


 
EMBROIDERING TUTORIAL
——————————————————————————————————————————————————————————————
——
48
Hooping fabric in the small embroidery frame
The procedure for hooping fabric in the small
embroidery frame is described below.
The same procedure is used to hoop the fabric in
the medium embroidery frame.
For details on hooping fabric in the large
embroidery frame and the extra-large
embroidery frame, refer to “Hooping the Fabric”
on page 91.
2
Loosen the screw on the outer frame.
1 Screw
3
Place the fabric with the right side up on top
of the outer frame.
The outer frame does not have a front or
back side. Either side can be used as the
front.
4
Press the inner frame into the outer frame.
Be sure that there are no wrinkles in the
fabric after it is stretched in the embroidery
frame.
5
Lightly tighten the screw, and then pull the
edges of the fabric.
6
Securely tighten the screw, and then check
that the fabric is taut.
After stretching the fabric, lightly tapping it
should produce a drum-like sound.
Firmly clamp together the inner and outer
frames so that the bottom of the inner
frame is lower than the bottom of the outer
frame.
1 Inner frame
2 Outer frame
3 Bottom of inner frame
Using the included disc-shaped
screwdriver, firmly tighten the screw.
1 Disc-shaped screwdriver
The amount that the fabric is stretched and the use
of stabilizer material differ depending on the type
of fabric being embroidered. Try various methods
to achieve the best embroidering results. (Refer to
“Hooping techniques” on page 222.)
Memo
This embroidery machine can also be used
with the optional cap frames. (Refer to
“Using the Optional Cap Frame” on
page 225.)