Brother 884-T05 Sewing Machine User Manual


 
BASIC SETTINGS AND HELP FEATURE —————————————————————————————————————————————————————————
——
200
1
Touch or to select the desired
setting.
The key appears as when “ON” is
selected, and it appears as when
“OFF” is selected.
Each touch of the key turns the setting
either on or off.
Note
This setting is not applied to the trimming
of threads between characters in alphabet
patterns. (Refer to “Trimming the threads
between characters” on page 169.)
Memo
The number of jump codes cannot be
specified for data other than Tajima
embroidery data (.dst).
When using Tajima embroidery data (.dst)
2
If “ON” is selected, touch and to
select the number of feed codes.
The desired setting is displayed.
A value between 1 and 8 can be specified.
For example, if 3 is specified, sequential 3
jump codes will be converted to the trim
code. But sequential 2 jump codes will not
be converted to the trim code, it will be
sewed as the feed (jump) stitch.
Note
You need to set the jump number same as
the number that was used when the
particular Tajima data was created.
If the jump number is not matched, either
unexpected trim or no trimming at trim
expected point will happen.