Filter
Top Products
BASIC SETTINGS AND HELP FEATURE —————————————————————————————————————————————————————————
——
204
Changing the speaker
volume
The volume of operation sounds (which are
produced when a key is touched in a screen or a
button is pressed in the operation panel) and alarm
sounds (which indicate that an error has occurred)
can be changed.
The speaker volume can be set to “OFF” or a
setting between “1” and “5”. When “OFF” is
selected, no sound is produced from the speaker.
When the embroidery machine is purchased, “5” is
selected.
The speaker setting can be specified from page 4/5
of the settings screen.
1
Touch and to select the desired
speaker volume.
X Check that the desired speaker volume is
selected with the operation sound
produced when a key is touched.
Specifying thread sensor
If thread sensor is set to “OFF”, the machine does
not stop until embroidering is finished, even if the
thread breaks or there is no more thread in the
bobbin. Set thread sensor to “ON”, except when it
is necessary to set it to “OFF”.
When the machine is purchased, “ON” is selected.
The thread sensor can be specified from page 4/5 of
the settings screen.
1
Touch or to select the desired
setting.
Note
● Normally, set thread sensor to “ON”.
When thread sensor is set to “OFF”, the
machine will not be able to detect if the
upper thread has become tangled.
Continuing to use the machine with
tangled thread may cause damage.