Filter
Top Products
OTHER BASIC PROCEDURES
—
——————————————————————————————————————————————————————————————
——
100
Switching the Thread Colors on the Screen
If a thread color on the spool stand is different than the needle position thread color on the screen, the thread
colors on the screen can be switched to match the spool stand thread color position. This function works
only before embroidering. Once embroidering begins this function will not be available.
1
Touch .
X The spool selection screen appears.
2
Touch the number of the first needle bar that
will be switched.
• To cancel the selection, touch the same
needle number again.
3
Touch the number of the other needle bar
that will be switched. The two needle
numbers are connected with an arrow.
• To cancel the selection, touch the same
needle number again.
4
Touch to switch the two thread
colors.
5
After making the desired changes, touch
.
Note
● Once the thread colors are switched, all
changes that were previously applied with
the temporary needle bar setting will be
canceled.