Filter
Top Products
12 Installation
The control panel must be installed by suitably qualified engineers familiar with the installation of
fire detection systems. In addition, it is recommended to refer to the following information:
• Current edition of the IEE wiring regulations.
• Current edition of BS5839-1 or the installation standards for the relevant country.
• Any specific site requirements.
• Any field device installation instructions.
• Any data sheet provided for the installation of Intrinsically Safe devices.
Notes:
The rating plate, containing essential electrical information is located inside the panel
on the inside face of the door.
The mains supply cable should be a minimum of 1mm
2
copper protected by a 5A fuse.
An appropriate lockable double pole disconnect device shall be provided as part of the
building installation. This device must have a minimum contact gap of 3mm.
12.1 Electrical Safety
WARNING: Read this section completely before commencing installation.
Prior to commencing installation of the control panel, ensure that adequate
precautions are taken to prevent damage to the sensitive electronic components on
the display board and the control board due to electrostatic discharge. You should
discharge any static electricity you may have accumulated by touching a
convenient earthed object such as an unpainted copper radiator pipe. You should
repeat the process at regular intervals during the installation process, especially if
you are required to walk over carpets.
The panel must be located in a clean, dry position, which is not subject to shock or
vibration and at least 2 metres away from pager systems or any other radio transmitting
equipment. The operating temperature range is 0ºC to 40ºC; maximum humidity is
95%.
12.1.1 IMPORTANT NOTES ON BATTERIES:
DANGER:
Batteries are electrically live at all times, take great care never to short circuit
the battery terminals.
WARNING:
Batteries are often heavy; take great care when lifting and transporting
batteries. For weights above 24 kilos, lifting aids should be used.
DANGER:
Do NOT attempt to remove the battery lid or tamper with the internal
workings of the battery. Electrolyte is a highly corrosive substance, and
presents significant danger to yourself and to anything else it touches. In
case of accidental skin or eye contact, flush the affected area with plenty of
clean, fresh water and seek immediate medical attention.
Valve Regulated Lead Acid (VRLA) batteries are “low maintenance”, requiring no
electrolyte top-up or measurement of specific gravity.
WARNING:
Only clean the battery case with a cloth that has been soaked or dampened
with distilled water. Do not use organic solvents (such as petrol, paint thinner,
benzene or mineral spirits) or other materials that can substantially weaken
the case. Do not use a dry cloth as this will generate static electricity, which
in turn may lead to an explosion.
WARNING:
Avoid operating temperatures outside the range of -15°C/5°F to +50°C/122°F
for float/standby applications.
The recommended normal operating temperature is 20°C.
HIGH TEMPERATURE will reduce battery service life. In extreme cases this
Page 13 of 40