Filter
Top Products
D623 Series/D625 Series | User's Guide | Check System Status
.
Bosch Security Systems | 9/04 | 46841E 9
Check System Status
When the system is Off, press [CMD] to show the
current system status. The following message may
appear:
Table 4: System Status Messages
System Status
Message
Description
System OK
Indicates there are no system
troubles.
System Trouble!
Press [4] to view
Indicates there is a system trouble.
Refer to Check System Troubles
(Cmd 4) on page 20 to determine
the nature of the trouble.
Points faulted
Press [0] to view
Indicates the system has faulted
points. Refer to View Faulted
Points on page 15 for more
information.
Log Out of the System
The system remembers passcodes entered for
approximately 10 sec. after you stop pressing keys. To
log out of the system, press the [CMD] key twice.
Logged Out appears on the keypad display.
Silence Alarms
When an alarm occurs, the alarm tone sounds and the
display shows the point(s) in alarm. If you enter your
passcode before the system dials your security
company, the alarm report is aborted.
1. The keypad displays the point(s) in alarm.
Enter code to
silence alarm
Alarm Pt4
Living Room
2. Enter your passcode to silence the alarm and turn
the system off (if it was turned on). An alarm
report is sent to your security company if the
alarm is not acknowledged in time.
The display continues to show the point (or
points) that caused the alarm.
Silenced alarms
listed below
Alarm Pt8
Motion Detector
To remove
silenced alarms
from display,
hold Cmd
3. Press and hold [CMD] to remove the alarm
messages from the keypad display. Refer to
Section View Alarm Memory (Cmd 40) on page 21 to
see which points caused the alarm.