Filter
Top Products
D623 Series/D625 Series | User's Guide | Renew One-time Passcodes (Cmd 53)
20 Bosch Security Systems | 9/04 | 46841E
Renew One-time Passcodes
(Cmd 53)
I can perform this command.
I cannot perform this command.
One-time passcodes can only be used once to turn the
system off. This command allows those with the
applicable authority level to renew previous One-Time
passcodes. Once renewed, the One-Time passcode is
again able to turn the system off only once.
1. Make sure the system is turned off (On indicator is
off).
2. Press [CMD] [5] [6]. The keypad may prompt you
to enter your passcode.
3. Enter your passcode if necessary. The keypad
scrolls through the available one-time passcodes.
To renew all
One-time codes
Press 0*.
To renew code 5
Press 5*.
4. Press [0] [*] if you want to renew all one-time
passcodes or press the passcode number followed
by [*]. For example, if you want to renew Passcode
5, press [5] [*].
5. If you press [0] to renew all one-time passcodes,
the keypad displays:
All one-time
codes renewed.
6. If you select a single passcode to renew, like
Passcode 5, the keypad displays:
One-Time Code 5
renewed.
7. The system returns to the normal display.
Check System Troubles (Cmd 4)
Your system emits a trouble tone and displays the
System Trouble message to alert you to a system
trouble event, like low batteries. Use this command to
learn what is causing the trouble and the steps to take
to correct it.
1. The system may be on or off when a system
trouble occurs. If the system is on, you must turn it
off to check the trouble. The keypad displays:
Trouble! Press
Cmd 4 to view.
2. Press [CMD] [4]. The trouble tone silences and the
keypad scrolls through the list of troubles. Follow
the keypad display instructions to view the trouble
events.
Point Trouble!
Press 8 to view.
Alarm Memory!
Press 0 to view.
Date/time lost!
Press 5 to set.
System Trouble!
Press 2 to view.
To Test System,
press 1.
To Walk Test,
press 4.
To reset,
Press 7.
System OK!
Press Cmd.
3. Press [CMD] to return the keypad to the normal
display.
The trouble tone continues until the situation is
acknowledged.
The trouble tone for AC Failure events
sounds at all keypads in all areas.
However, the trouble tone must be
silenced in each area (silencing it in one
area does not silence it in the other
areas).