Filter
Top Products
D623 Series/D625 Series | User's Guide | Basic Pager Reports
32 Bosch Security Systems | 9/04 | 46841E
Table 7: Character Code Information
Display Description
A# Area number
Pt## Point number
Dv### Device number
Ln## Phone line number
Mn# Minutes until Auto Arm Sked
Cd## User Code number
Op## Output number
Ks## Keyswitch number
U## User number
## Communication status for Routing Destinations
1 and 2
- (dash) Destination disabled
A Aborted
D Deleted from pending buffer by control panel
reset
F Faulted
L Local
P Pending
S Sent
Basic Pager Reports
A pager’s display can show up to four fields of
information in the following order:
Figure 7: Pager Display format
(Account Number) - (Event Number) - (Area Number) - (Point/User Number)
• Account Number: 4-digit account number. If the
account number is greater than four digits, the first
four digits are sent.
• Event Number: Panel event numbers. See Panel
Event Descriptions on page 43 for information on
control panel events.
• Area Number: Area number the faulted point is
assigned to.
• Point/User Number: Point number assigned to
the faulted point. This field can also show a User
ID number.
Depending on its configuration, your pager can display
any combination of the four fields shown in the order
above with or without field separators. For example:
• Account Number: 1234
• Event Number: 08
• Area Number: 02
• Point Faulted: 21
A pager display configured to show all four fields with
separators using the sample information from above
would look like:
1234-08-02-21
A pager display configured to show all four fields
without separators using the sample information from
above would look like:
1234080221.
Contact your security company to modify pager
display configuration.
• User IDs 1 to 32 are reserved for system user.
• User ID 252 is reserved for sked operation.
• User ID 253 is reserved for remote telephone
communication.
• User ID 254 is reserved for remote programming
communication.
• User ID 255 is reserved for keyswitch operation.