Filter
Top Products
D623 Series/D625 Series | User's Guide | Turn the System On with No Exit Tone (Delay Silent)
.
Bosch Security Systems | 9/04 | 46841E 13
2. Press [ALL ON] if you want to turn the system All
On, or press [PART ON] if you want to turn the
system Part On. Press [CMD] [3] if you want to
turn the system Part 2 On. The keypad may
prompt you to enter a valid passcode.
3. Enter your passcode if necessary. The keypad
display shows the following for turning the system
All On:
60 seconds to
All On.
To bypass points
Press Bypass.
For no delay
Press No Delay.
Pressing [NO DELAY] begins a 10-sec. “last
chance” window in which you have 10 sec. to
decide if you want to allow the system to arm.
During this window, the display scrolls through the
following messages: No exit time! System
arming. Do not exit! If you decide not to
allow the system to arm, enter your user passcode.
If all points are normal, the display shows the
following for Part On (the display shows Part 2 On
if the system is Part 2 On):
To bypass points
press Bypass.
60 seconds to
Part On.
For no delay
Press No Delay.
4. To turn the system on (All On, Part On, or Part 2
On) with no delay, press [NO DELAY].
The keypad scrolls the following for All On:
Do not exit!
No exit time!
System arming.
Enter code to
turn system off
Smiths Residence
All On
On with No Delay
The keypad scrolls the following for Part On (the
display shows Part 2 On if the system is Part 2
On):
Do not exit!
No exit time!
System arming.
Enter code to
turn system off
Smiths Residence
Part On
On with No Delay
5. When the system is All On with No Delay, the
keypad displays the following:
On with No Delay
Smiths Residence
All On
If the system is Part On or Part 2 On with No
Delay, the keypad displays the following (the
display shows Part 2 On if the system is Part 2
On):
On with No Delay
Smiths Residence
Part On
The On indicator turns on and blinks, indicating
the system is on with no delay.
6. To turn the system off, enter your passcode.
Turn the System On with No Exit
Tone (Delay Silent)
Use this command to turn the entire system All On,
Part On, or Part 2 On without any exit tones.
Remember that turning the system on with no exit tone
eliminates the tone emitted by the keypad intended to
alert occupants that the system is about to arm.
This command is useful when you wish to arm the
system, but not disturb the occupants while the system
counts down prior to arming.
1. Make sure all points are normal (not faulted).
2. Press and hold the appropriate key to silence the
exit tone. The keypad may prompt you to enter a
valid passcode.