Filter
Top Products
D623 Series/D625 Series | User's Guide | Keypad Adjust (Cmd 49)
10 Bosch Security Systems | 9/04 | 46841E
Keypad Adjust (Cmd 49)
I can perform this command.
I cannot perform this command.
Use Command 49 to adjust the keypad sounder
volume and the display brightness.
1. Press [CMD] [4] [9]. Enter a valid passcode if
prompted.
2. To adjust the keypad sounder volume, press and
hold the [*] key and then press [1] to increase the
volume or [4] to decrease the volume.
3. To adjust the keypad display brightness, press and
hold the [*] key and then press [3] to increase the
brightness or [6] to decrease the brightness.
4. Press [CMD] to exit this command function when
all adjustments are made.
Turn the System Off
Entry Delay Time (to be filled in by your security
company).
You have __________ sec. to enter premises and turn
system off.
Enter your passcode to turn the security system off.
When the system is on, you must enter through a
designated entry door to prevent an alarm. Opening a
designated door, such as the Front Door, starts the
entry delay. During entry delay time, the keypad emits
a double tone to remind you to turn the system off.
Enter your passcode before the entry delay time
expires to turn the system off.
If you enter through the wrong door or fail to turn the
system off before the entry delay time expires, you may
cause an alarm. If an alarm occurs, silence the alarm by
entering your passcode and call your security company
to let them know that there is no emergency situation.
1. When the system is on, the On indicator
illuminates. If the system is All On, the keypad
display shows:
Smiths Residence
All On
If the system is Part On, the keypad display
shows (Part 2 On shows if the system is Part 2
On):
Smiths Residence
Part On
2. Enter your passcode to turn the system off. Once
the system is off and there are no faulted points,
the keypad displays the idle text (second line) as
shown below:
Smiths Residence
OK for All On
Turn the System All On (All On
or Cmd 1)
Exit Delay Time (to be filled in by your security
company).
You have __________ sec. to exit premises before
system turns on.
Use this command to turn on the entire system. Once
you press the [ALL ON] key or enter Cmd 1, the Exit
Delay timer starts its countdown. The length of exit
delay is programmed by your security company.
When your system is ready to turn All On, it displays
OK for All On, indicating all points are normal,
such as no open doors or windows and no one standing
in front of a motion detector.
Smiths Residence
Ok for All On
If your keypad displays a message indicating the
system is not ready to arm (such as Not Ready to
Arm), check all doors and windows to see if any are
open or if someone or something is in front of a motion
detector. If all protected doors and windows are closed
and no motion detectors are blocked and the keypad
still displays Not Ready to Arm, contact your
security company for assistance.
In the example below, the exit delay is 60 sec. Leave
before the exit time expires. Leaving after exit delay
expires causes an alarm event.
1. Make sure all points are normal (not faulted). If
your system has a faulted point (door/window
open), you can either close it or bypass it (see
Bypass Points 1 on page 18).
2. Press [ALL ON] or [CMD] [1]. The keypad may
prompt you to enter a valid passcode.