Frye FP35 Manual

A SERVICE OF

next previous

114 FONIX FP35 Hearing Aid Analyzer

• Makesureallcablesinthecompartmentareputawaysotheywillnot

interfere with replacing the speaker.

• Setthespeakerbackinthecompartment.Asyoudothis,guidethespeak-

er wire so it stays to the side of the speaker, not underneath it.

5.2.3 External Speaker Setup

If desired, you can use an external speaker to perform your real-ear measure-

ments. The external speaker can be mounted to a floor stand or to a swing arm.

A swing arm is especially nice because you can move the speaker around the

patient when you switch ears, rather than move your patient around the speak-

er.

Figure 5.2.3—External sound field speaker setup

To set up your FP35 software to use an external speaker:

1. Press [MENU] from the Opening screen to enter the Default Settings menu.

2. Press [NEXT] to enter the Advanced Default Settings menu.

3. Select SPEAKER under RESETS with [

∨, ∧] keys.

4. Set AUTO with [<, >]. All real-ear measurements will now be done with

the external speaker and all coupler measurements will be done with the

internal speaker.

5. Press [EXIT] to return to the Opening screen.

6. Press [F2] to enter Real-Ear Mode again.