Filter
Top Products
16
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need.
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
pr
Cable Adjustments
Tools Needed:
Pliers/Wire
Cutter
Flat Tip
Screwdriver
Locking Pliers
Step Ladder
Cam Peak
Straight Up
10
Torquemaster
®
Torquemaster
®
Plus
Counterbalance Cable Aligned
and Seated In The First Groove
Starting on the right hand side, rotate the
cable drum until the set screw faces directly
away from the header. Torque tube cam peak
should be pointing straight up.
NOTE: Illustrations show the right hand cable
drum, left hand cable drum is symmetrically
opposite.
NOTE: Cable tension is set during the initial
door installation. If there is slack between the
counterbalance cable and the cable drum or
unequal tension between the right and left
hand counterbalance cables, the
counterbalance cables will have to be
readjusted. If there is no slack and cable
tension is equal, proceed to Step 11.
Loosen the set screw no more than 1/2 turn.
Using locking pliers, pull on the end of the
cable to remove all cable slack.
Check to ensure the cable is aligned and
seated in the appropriate groove(s) of the
cable drum. Snug the set screw, and then
tighten an additional 1-1/2 turns. Left side will
be
adjusted in Step 12.
IMPORTANT! ENSURE THE CABLE IS ALIGNED
AND SEATED IN THE APPROPRIATE GROOVE(S)
OF THE CABLE DRUM PRIOR TO WINDING
SPRINGS.
Measure approximately 6” of cable, cut off
excess cable, tuck end into cable drum
(Torquemaster
®
) or insert end in hole of cable
drum (Torquemaster
®
Plus).
Right Hand Drum
Cut Cable Here
Set Screw
1/2 Wrap
6”
1-1/2 Wrap
6”
Cut Cable Here
Cam Peak
Straight Up
Right Hand Drum
Set Screw
Hole
Counterbalance Cable Aligned and
Seated In The First/Second Groove