Filter
Top Products
Chapter 5 Installing the Tracer MP581 programmable controller
82 BAS-APG001-EN
Installing the door
To install the enclosure door:
1. Unpack the door and check for missing or damaged parts.
Check to make sure that the magnetic latches and touch screen (if
ordered) are installed. Check for any cracks in the plastic.
2. Hold the door at a 90° angle from the enclosure as shown in Figure 43
on page 82.
Figure 43. Aligning the enclosure door
3. Align the hinge pegs on the door with the hinge holes on the
enclosure.
4. Gently lower the door until it rests securely in the hinge holes.
5. Verify that the door swings freely on the hinges and that the magnetic
latches hold the door securely when it is closed.
Removing the door
Remove the door to simplify wiring or when upgrading the controller with
a door-mounted operator display.
To remove the enclosure door:
1. Open the door to a 90° angle from the enclosure.