Filter
Top Products
BAS-APG001-EN 121
Chapter 8
Network variable bindings
Overview
The LonTalk communications protocol allows data to be shared between
devices (stand-alone or with a BAS) on a LonTalk network. This is called
peer-to-peer communication. As an example of peer-to-peer communica
-
tion, two or more devices serving the same space share data, such as a
temperature reading, without having to pass the data through a BAS.
Network variables are used to share data between devices. The method
used to direct data from one device to another is called network variable
binding, or just binding. A network variable output from one device is
bound to a network variable input on another device. An output variable
from one device can be bound to input variables on many other devices.
Binding network variables
Each network variable is a standard type. This standard type is referred
to as a standard network variable type (SNVT). To bind two variables
together they must be the same SNVT. For example, an output of type
SNVT_temp_p can only be bound to an input of type SNVT_temp_p. For
more information about SNVTs, see the LonMark™ Web site (www.lon
-
mark.org). From that Web site you can download the official list of
SNVTs.
IMPORTANT
Only LonTalk devices can use network variable binding. Devices on
other communications links do not have this capability.
BAS communications typically do not require the use of network variable
binding because a Tracer Summit BCU will automatically bind to the
proper data in a device. However, communications speed may be
increased between two devices by binding their data rather than having
the BAS read the information from one device and then broadcast it to
another.
Use the Rover service tool to create bindings. (See the Rover Operation
and Programming guide, EMTX-SVX01E-EN.)