Filter
Top Products
SDC / DHC Operation
EN2H-0221GE51 R0808 37
If the ¤ button is pressed and held for approx. 3 s, the INFO
TIME parameter appears.
With this parameter, the time it takes for automatic return to the
basic display can be specified.
OFF No return. The last selected information display
continuously remains in the basic display until the
next change.
1 ... 10 min Automatic return from the information level after the
specified time (in 0.5 minute increments).
OFF
5.1.2.7.1 Temperature displays
Information Display Condition Remarks
Outside
temperature (1)
Determined
value/Current
value
Outside
temperature (1)
Min./max. value
(0:00 to 24:00
hours)
Outside sensor
connected and no fault
message
Outside
temperature (2)
Determined
value/Current
value
Variable input
configured as OS2
Connection OS2 to variable
input VI1, VI2 or VI3
Outside
temperature (2)
Min./max. value
(0:00 to 24:00
hours)
OS2 connected, no fault
message
EM-SET (energy
management
setpoint)
"EM-SET" Highest hot-water setpoint
and highest heating circuit
setpoint in the system
Heat generator
temperature (1)
Setpoint/Actual
value
Heat generator
specified
Code 1 only appears if BS2
is present
Heat generator
temperature (2)
Setpoint/Actual
value
Variable input
configured as BS2
Connection BS2 to variable
input VI1, VI2 or VI3
Setting time fo
r
automatic return
Setting range
Factory setting