Filter
Top Products
6-21
Cisco ASA 5500 Series Adaptive Security Appliance Getting Started Guide
78-17611-01
Chapter 6 Scenario: DMZ Configuration
Configuring the Security Appliance for a DMZ Deployment
Alternatively, if the address of the source host or network is preconfigured,
choose the source IP address from the IP Address drop-down list.
c. Enter the netmask for the source IP address or select one from the Netmask
drop-down list.
Step 4 In the Destination area:
a. In the IP address field, enter the public IP address of the destination host or
network, such as a web server. (In this scenario, the public IP address of the
DMZ web server is 209.165.200.226.)
Step 5 In the Protocol and Service area, specify the type of traffic that you want to permit
through the adaptive security appliance.
a. From the Protocol drop-down list, choose tcp.
b. In the Source Port area, click the Service radio button, choose “=” (equal to)
from the Service drop-down list, and then choose Any from the next
drop-down list.
c. In the Destination Port area, click the Service radio button, choose “=” (equal
to) from the Service drop-down list, and then choose HTTP/WWW from the
next drop-down list.