Filter
Top Products
3-3
Cisco ASA 5500 Series Adaptive Security Appliance Getting Started Guide
78-17611-01
Chapter 3 Installing Optional SSMs
Cisco 4GE SSM
Installing the Cisco 4GE SSM
To install a new Cisco 4GE SSM for the first time, perform the following steps:
Step 1 Power off the adaptive security appliance.
Step 2 Locate the grounding strap from the accessory kit and fasten it to your wrist so
that it contacts your bare skin. Attach the other end to the chassis.
Step 3 Remove the two screws (as shown in Figure 3-2) at the left rear end of the chassis,
and remove the slot cover.
Figure 3-2 Removing the Screws from the Slot Cover
3, 8 SPEED Off
Green
Amber
10 MB There is no network activity.
100 MB There is network activity at
100 Mbps.
1000 MB
(GigE)
There is network activity at
1000 Mbps.
4 POWER Green On The system has power.
5 STATUS Green
Green
Amber
Flashing The system is booting.
Solid The system booted correctly.
Solid The system diagnostics failed.
Table 3-1 Cisco 4GE SSM LEDs (continued)
LED Color State Description
119642
LINK SPD
3
LINK SPD
2
LINK SPD
1
LINK SPD
0
MGMT
USB2
USB1
FLASH
P
O
W
E
R
S
T
A
T
U
S
FLASH
V
P
N
A
C
T
IV
E