Filter
Top Products
2000 Series | Program Entry Guide | 18.0 Keypad Programming EN | 66
Bosch Security Systems | 7/05 | 35114F
18.3 Modify Mode
In Modify Mode you can modify the entry for any
prompt. Pressing the [A] key in View Mode puts the
system in Modify Mode. MOD (short for modify)
appears to the right of the group and prompt numbers.
Refer to Figure 3.
Figure 3: Modify Mode
1.1 MOD
B
The current entry for the prompt is cleared from
line 2 of the display. The first character of the
scroll list appears in the leftmost position of the
display. Using the scroll list to complete the new
entry is described in Section 18.4 Scroll Lists. Refer
to Table 21.
0101
0101
0101
Even though the current value of the prompt
was cleared when you entered Modify
Mode, you can leave Modify Mode and
return to View Mode without changing the
entry by pressing the [CLEAR] key.
Table 21: Modify Mode Keys
A-
Key
Pressing the [A] key while in View Mode enters Modify Mode. Pressing the [A] key while in Modify Mode
writes the displayed value to control panel memory and returns to View Mode. The display shows the new
value. Because the system is no longer in Modify Mode, MOD no longer appears to the right of the group and
prompt numbers.
B-
Key
Pressing the [B] key in Modify Mode scrolls backward through the scroll list of characters. Refer to Section
18.4 Scroll Lists.
C-
Key
Pressing the [C] key in Modify Mode scrolls forward through the scroll list of characters. Refer to Section
18.4 Scroll Lists.
*-Key Pressing the [*] key in Modify Mode accepts the character displayed in the current character position and
then moves one character position to the right.
Do not press the [*] key unless you intend to enter another character to the right of the current character
position.
If your entry is complete, press the [A] key to accept your entry.
Clear Pressing the [CLEAR] key in Modify Mode exits Modify Mode and returns to View Mode with out changing
the current value of the prompt.
0 to
9
Pressing the [0] to [9] keys in Modify Mode enters the corresponding digit in the display in the current
character position. You must press the [*] key to move to the next character position.
18.4 Scroll Lists
Alphabetic characters are valid entries for many
prompts. Scroll lists allow you to enter alphabetic and
other special characters without entering numeric
codes for these non-numeric characters.
When you press the [A] key to move to Modify Mode
from View Mode, the system erases the current value
of the prompt from the display, adds MOD to the right
of the group and prompt numbers in the top line of
the display, and displays the first character of the scroll
list in the leftmost character position of the bottom line
of the display.
Scroll lists display allowable alphabetic characters (A
to Z) first, then the allowable numeric characters (0 to
9), then the special characters (! # ‘ , - / : < >), and
finally the “space” character.
The [C] key moves forward through the scroll list. The
[B] key moves backward through the scroll list.
18.5 Yes and No Entries
In View Mode the system spells out YES or NO for
Yes/No prompts. When you enter Modify Mode
the system always displays N for no. Pressing
either the [B] key or [C] key toggles Y for yes into
the display.