Filter
Top Products
2000 Series | Program Entry Guide | 15.0 Passcodes EN | 59
Bosch Security Systems | 7/05 | 35114F
15.0 Passcodes
If you are programming from the keypad, you must
exit the Programming Mode to program passcodes.
Use Show User ([6] key) and your installer passcode.
Follow the instructions in the Security System User Guide.
1 Instir Code
Default:
654321
Selection:
0 to 9, Blank
Installers enter this passcode to perform keypad
programming. They can also use it to perform tests
and to change passcodes. You cannot use the installer's
passcode to turn the system off.
The installer passcode always requires six digits. Even
when the
Passcode Length
prompt is less than six,
you must enter six digits for this prompt. If you enter
less than six digits and increase the
Passcode Length
later, the installer code is disabled.
The D5200 Programmer and remote programmers do
not let you program the same passcode for the installer
and a user. The system prevents users changing their
own passcodes at the keypad from duplicating the
installer code. However, the system does not prevent
installers programming from the keypad, from
programming the same passcode for the installer and a
user.
Use the D5200 Programmer or remote programmer to
fill this prompt with spaces to disable the installer
passcode.
2 Passcode Length
Default:
3
Selection:
3 to 6
You can fix the length of user passcodes from three to
six digits. All passcodes are the same length.
If you shorten the passcode length after
entering passcodes, you could possibly
create duplicate passcodes. For example,
passcodes 1235 and 1236 both shorten to
123. If you lengthen passcodes you disable
some. For example, if you add passcode
396 and then increase the passcode length
to four digits, 396 becomes 396F. If you
cannot enter an F from the keypad,
passcode 396 is disabled.
3 Code 8 = Duress
Default:
No
Selection:
Yes, No
0 No
1 Yes
Setting this prompt to Yes makes the passcode for
User 8 the duress passcode. The passcode operates
the system normally and sends a Duress Report to
the receiver.
4 Passcode Rquired
Default:
No
Selection:
Yes, No
0 No
1 Yes
Setting this prompt to Yes configures the system so
that users must enter a passcode to turn the system
on (press [9] and enter passcode).
Pressing [9] after entering the passcode turns the
System All On with No Delay (press [9], enter
passcode, press [9]).
To turn the system Part On users press [0] and
then enter a passcode (press [0], enter passcode).
Pressing [0] after entering the passcode turns the
System Part On with No Delay (press [0], enter
passcode, press [0]).