Filter
Top Products
D1260/D1260B | Owner's Manual | Appendix - Supplementary Information for Adding Passcodes
76 Bosch Security Systems | 9/04 | 50410D
Appendix
Supplementary Information for Adding
Passcodes
Use the information contained in this Supplement to
help you add user passcodes.
User Authority Levels
Your security company uses the information contained
on this page to establish authority levels for system
users. For each of the 1- 14 authority levels, each
command center function is either enabled (E),
disabled (blank), or Passcode enabled (P). A function
that is enabled (E) is available to all users. A function
that is passcode enabled (P) is only available to users
assigned an authority level that includes that function.
If you do not want a particular command included in a
given authority level, leave it blank.
If you are having trouble understanding the concept of
authority levels, try this simple exercise. Refer to the
column titled E/P on the next page. Notice that your
security technician has marked some of the cells in this
column with the letter “E”, others the letter “P”, while
others are left blank. An “E” indicates that this function
is enabled for all authority levels. A “P” indicates that
the function is passcode protected. Look across the
same row, and notice that some of the cells in the
authority level area have the letter “E”. For each
authority level in which an “E” appears, this function is
enabled (with a passcode required). A blank cell in the
E/P column means that this function is unavailable for
any authority level.
Under the heading Authority Level, you’ll see columns
1-14, representing the fourteen authority levels. Now
look at the column labeled 1. Following down this
column, you’ll see that some cells are blank while some
contain the letter “E”, which stands for enabled.
Wherever there is an “E”, it means that that function is
available to users with an authority level of 1.
Passcode Worksheet
The passcode worksheet presents the information discussed previously onto one page, and also includes the user’s
ID number, assigned passcode, and his or her name.
An important piece of information included in the passcode worksheet is the listing of areas to which the user has
access, along with the authority level assignment for each of those areas.
User Interface
Authority Levels
# Functions* Command E/P 1 2 3 4 5 6 7 8 9 10 11 12 13 14
1 Disarm ?
P
E E E E E
2 Master Arm Delay ? CMD 1 P E E E E E
3 Master Arm Instant? CMD 11 E E
4 Perimeter Instant ? CMD 2 P E E E E
5 Perimeter Delay ? CMD 3 P E E E E
6 Watch Mode ? CMD 6 E E E E
7 Perimeter Part ? CMD 8 P E E E E
8 View Area Status ? P E E
9 View Memory ? CMD 40 E E E E
10 View Pt Status ? E E E E
11 Walk Test ? CMD 44 E E E
12 Fire Test ? CMD 58 P E E
13 Send Report ? CMD 41/42 P
14
♦Door Control ?
CMD 46 P E E
♦Cycle Door ?
E E E
♦Unlock Door ?
E E E
♦Secure Door ?
E E
37
♦Access Control
Level?
P E
15 Change Display ? CMD 49 E E
16 Change Time/Date ? CMD 45 E E
17 Change Passcode ? CMD 55 P E
18 Add User ? CMD 56 P E
19 Del User ? CMD 53 P E
20 Extend Close ? CMD 51 P
21 View Log ? E E