Filter
Top Products
D1260/D1260B | Owner's Manual | Part III: Advanced Commands - CHG PASSCODES ? (COMMAND + 5 + 5)
52 Bosch Security Systems | 9/04 | 50410D
• To avoid conflicting with other passcodes and
duress codes, your system does not let you change
passcodes to an existing passcode or to within plus
or minus 2 of an existing passcode. For example, if
1234 were an existing code, your system would not
let you change your code to 1232, 1233, 1234,
1235, or 1236.
Using Chg Passcodes
1. Ensure your keypad shows idle disarmed text.
2. Press the COMMAND key. The display shows
*System Command*
.
3. Press the 5 key and then the 5 key.
If you prefer, you may use the Command
Menu in place of steps 2 and 3 to initiate
this function.
Press the MENU> soft key to enter the
Command Menu.
Press NEXT> soft key repeatedly.
When you reach the CHG PASSCODES
?> prompt, press its adjacent soft key.
4. You will prompted for your passcode.
As soon as a number is pressed,
Entering:
appears
on the third line next to the asterisks.
The passcode is shown as asterisks (*) when
entered and advance from the right side of the
display to the left until all passcode digits are
entered.
5. The display changes to
Enter new passcode:
Enter the new passcode.
As soon as a number is pressed,
Entering:
appears
on the third line next to the asterisks.
The passcode is shown as asterisks (*) when
entered and advance from the right side of the
display to the left until all passcode digits are
entered.
6. Press the ENTER button.
If an invalid passcode is entered, the command
center will momentarily display
Passcode is
already in use. Please try again.
7. If the new passcode is valid, the display changes to
Enter new passcode again:
Enter the new passcode again.
As soon as a number is pressed,
Entering:
appears
on the third line next to the asterisks.
The passcode is shown as asterisks (*) when
entered and advance from the right side of the
display to the left until all six passcode digits are
entered.
8. If the passcode matches the previously entered
passcode, the display changes to
Passcode
changed.