Filter
Top Products
D1260/D1260B | Owner's Manual | Part II: System Commands - PERIMETR INST (COMMAND + 2)
22 Bosch Security Systems | 9/04 | 50410D
PERIMETR INST (COMMAND + 2)
Turn On the Perimeter With No Delays
Description
Use this function to turn on only the perimeter of your
building, leaving the interior of the building disarmed.
This function allows no exit or entry delay time
through the perimeter, including the designated exit
delay door.
This function is useful in residential systems when
everyone is home and ready to retire for the evening.
You can have the security of an armed perimeter, yet
move freely throughout the interior of the premises.
It is also useful in commercial systems when you are
working before or after business hours and wish to
have the perimeter armed. Remember there are no
entry or exit delays when you use this function. You
must disarm (turn off) the system to enter or exit the
premises.
Using Perimeter Inst:
1. Interior points are not armed with this command
and may remain faulted while arming with
COMMAND 2.
2. Press the COMMAND key.
The display shows
*System Command*
.
3. Press the 2 key.
If you prefer, you may use the Command
Menu in place of steps 2 and 3 to initiate
this function.
Press the MENU> soft key to enter the
Command Menu,
then press NEXT> soft key repeatedly.
until you reach the PERIMETR INST ?>
prompt, then press the adjacent soft key.
4. The display shows
Perimeter On Instant
.
After arming the perimeter without delays, you
cannot enter or exit the premises without
disarming the system. Opening a perimeter door
before disarming will generate an alarm. If this
happens, silence the alarm by turning off your
system and call your security company to let them
know that it is not an emergency situation.
5. To disarm your security system, enter your
personal passcode and press ENTER.
The display then returns to idle text.