Filter
Top Products
D1260/D1260B | Owner's Manual | Part II: System Commands - PERIMETR PART ? (COMMAND + 8)
Bosch Security Systems | 9/04 | 50410D 29
If you prefer, you may use the Command
Menu in place of steps 2 and 3 to initiate
this function.
Press the MENU> soft key to enter the
Command Menu.
Press NEXT> soft key repeatedly.
When you reach the WATCH MODE ?>
prompt, press its adjacent soft key.
Press ENTER.
3. The display briefly shows
Watch Mode is now
off.
The display returns to show idle text.
PERIMETR PART ? (COMMAND + 8)
Partially Turn On the Perimeter
Description
This function is used to turn on the perimeter of your
building while selected portions of the perimeter
remain turned off. Perimeter points that are not secure
(faulted) when this function is entered are automatically
bypassed and are not included in the system. This
function does not turn on the interior of your building.
Entry/exit delays are provided with this arming
command.
Use this function in residential systems to turn on the
front of your house while the interior and the rear
perimeter doors are left turned off, giving you freedom
of movement between the house and patio.
In commercial systems, when you need access to the
large overhead doors to receive deliveries, using this
function will allow you to keep the rest of the building
perimeter armed.
Using Perimetr Part:
1. The display shows disarmed idle text.
Press the COMMAND key. The display shows
*System Command*
.
2. Press the 8 key.
If you prefer, you may use the Command
Menu in place of steps 2 and 3 to initiate
this function.
Press the MENU> soft key to enter the
Command Menu.
Press NEXT> soft key repeatedly.
When you reach the PERIMETR PART ?>
prompt, press its adjacent soft key.
Press ENTER.
3. The display prompts the user to exit the area and
starts counting down from 10 seconds to arm the
system.
# is the number of seconds remaining, counting
down from 10 seconds, before the system is armed.