Filter
Top Products
D1260/D1260B | Owner's Manual | Part III: Advanced Commands - SERVICE MENU ? (9 + 9 + Enter)
Bosch Security Systems | 9/04 | 50410D 65
Using Print Log
1. Press the
Print Log ?>
soft key.
2. The display changes to
Enter start date:
Press the
Print all events>
soft key to print all
events in the log.
Press the
<Exit
soft key to exit this function and
return to idle text.
The events are sent to a connected printer and
display changes to
Printing all events in history
for three seconds before returning to idle text.
3. Enter the start date in the form of mm/dd.
For example, to enter 12/21 as the start date, press
1 + 2 + 2 + 1
.
Once you start entering digits, the
Print all
events>
soft key is replaced with the
Enter>
soft
key.
Press either the
Enter>
soft key or the ENTER
button.
4. If the date entered is valid, the events for that date
will be sent to a connected printer and the display
will show
Printing events.
for three seconds,
before returning to idle text.
Using Display Rev
1. Press the
Display Rev ?>
soft key.
2. The display will change to
*Bosch D9412*
Version 6-40
(D9412 and 6-40 are used as an example, other
panels could be D9112, D7412, D7212).
3. The display will return to idle text after 5 seconds.
Using Service Walk Test
The Service Walk Test function is only
available in the Service Menu for D9412
and D9112 panels. If the panel model is
D7412 or D7212, the Service Walk Test
will have to be enabled on the Function
list for the command center through the
panel’s programming.
1. When the display shows
### points remain to
be tested
you can begin. (### is the number of
points).