Filter
Top Products
D1260/D1260B | Owner's Manual | Part III: Advanced Commands - UNBYPASS A POINT? (COMMAND + 0 + 0)
Bosch Security Systems | 9/04 | 50410D 35
UNBYPASS A POINT? (COMMAND + 0 + 0)
Description
Unbypassing a point is a way to return a bypassed
point to the security system so that it can once again
respond to trouble and alarm conditions.
Using Unbypass a Point:
1. The display shows disarmed idle text.
Press the COMMAND key. The display shows
*System Command*
.
2. Press the 0 key twice.
If you prefer, you may use the Command
Menu in place of steps 2 and 3 to initiate
this function.
Press the MENU> soft key to enter the
Command Menu.
Press NEXT> soft key repeatedly.
When you reach the UNBYPAS A POINT
?> prompt, press its adjacent soft key.
Press ENTER.
3. You will prompted for your passcode. It will
appear on the display as asterisks (*).
4. The display changes to show
Enter point number
or press next key
.
5. If digits are pressed, the display shows
Enter point
number: #.
As soon as a digit key is pressed, the
display changes to
Entering point number:
.
(# is the point number that was entered)
If you know the point number you wish to
unbypass, enter the number and press the
Enter>
soft key or the ENTER button.
If you don’t know the number of the point you
wish to unbypass, you can view the list of devices
that can be unbypassed by pressing the
Next>
soft
key.
Continuously pressing
Next>
scrolls through the
available points that are currently bypassed.
When the point text of the point you wish to
unbypass appears, press the
Unbypass>
soft key.
One of the following messages displays (FRONT
DOOR is used here as an example):
•
FRONT DOOR is not bypassed
indicates the
point is not bypassed and the option is given
to bypass it.
•
FRONT DOOR is now bypassed.
indicates
the point was successfully bypassed.