Bosch Appliances D1260 Home Security System User Manual


 
D1260/D1260B | Owner's Manual | Part II: System Commands - Entering a Passcode
Bosch Security Systems | 9/04 | 50410D 15
Part II: System Commands
Below is a summary of the commands covered in this
section.
Some of these functions may not be
available in your system. Please consult
your security company to determine which
commands have been made available to
you.
If you attempt to enter a function that’s not available or
if the function is available in the system but your
passcode is not authorized to perform the function,
then
**No Authority**
will display on the Keypad.
Press the COMMAND key and then the one or two
digits shown in the table below to perform the function.
When you use a command to perform a function, the
displays in the function list below do not appear at
your keypad.
Some commands listed below may not be
available. Contact your security company
for more information.
Table 2: Keypad Commands
COMMAND Function
Master Arm
+
Master Arm Instant
Perimeter Instant
Perimeter Delay
Silence Trouble Sounder & Clear
Trouble Display
+
View Memory
+
Walk Test
+
Reset Sensors
Watch Mode
Special Alert
Perimeter Partial
Special Alert
+
Walk Test
Entering a Passcode
1. The display may prompt you to enter your
passcode.
2. The passcode is shown as asterisks (*) when
entered and advance from the right side of the
display to the left until all passcode digits (from a
minimum of 3 to a maximum of six) are entered.
3. Press ENTER.