Filter
Top Products
D1260/D1260B | Owner's Manual | Part I: Security system basics - Burglary Alarms
12 Bosch Security Systems | 9/04 | 50410D
Burglary Alarms
Burglary alarms are the second priority. When a
burglary point activates while your system is armed,
your keypad emits a steady high-pitched burglary tone.
The tone sounds for the time set by your security
company.
The keypad display shows the number of burglary
points activated, the point text then idle text.
If there is more than one point causing an alarm, the
display will show each point for three seconds before
showing the next one. When the last alarm is shown,
the next display is idle text followed by the first alarm
3 seconds
3 seconds
3 seconds
3 seconds
Silencing Burglary Alarms
Entering a personal passcode with the proper authority
level silences a burglary alarm and disarms the system
if it was armed.
The system will now display
*Alarm Silenced*
and then the number of points in alarm
### Alarms
and the custom text of all the points in alarm, in the
order of occurrence.
Entering COMMAND 4 clears the scrolling point text
from the display.
The *
Alarm Silenced*
message will continue to
alternate with idle text as a reminder that it is still
possible to view the text of the points in alarm by using
the View Memory function. See
VIEW MEMORY ?
(Command 40) for more information.
To clear the event memory and remove the *
Alarm
Silenced*
message from the display, press the Clear
Display> soft key.
The display will show the instructions for clearing the
message. Enter a valid passcode and press the Clear>
soft key.